Rough Country M1 Adjustable 0-2 Inch Leveling Struts | 2019-2026 Silverado/Sierra 1500 | 502065
Build your truck around the correct application instead of guessing at a generic spacer. Rough Country part 502065 is a vehicle-specific M1 monotube adjustable loaded leveling struts for 2019-2026 Chevrolet Silverado 1500 / GMC Sierra 1500, plus 2022 LTD / Limited. Serial Killer Customs lists the important fitment limits up front so you can verify the truck before ordering.
Key Specs & Benefits
- Manufacturer: Rough Country
- Part number: 502065
- Front lift / leveling: 0-2 inches adjustable; Rough Country ships them pre-set at 2 inches
- Drivetrain: 2WD / 4WD
- 46mm monotube body and 46mm digressive piston for consistent damping and body control.
- Height-adjustable spring-perch design; pre-set by Rough Country at 2 inches.
- Zinc-plated body, hardened chromed piston rod and vulcanized rubber bushings.
- 3-year Rough Country M1 warranty.
Vehicle Fitment
Fits: 2019-2026 Chevrolet Silverado 1500 / GMC Sierra 1500, plus 2022 LTD / Limited.
Important Fitment Warnings
- Cannot be installed with an additional strut spacer.
- Does not fit Denali / Denali Ultimate with Adaptive Ride Control.
- Does not fit AT4, AT4X, LT Trail Boss, Custom Trail Boss or ZR2.
- Does not fit diesel-engine trucks, Super Cruise-equipped trucks or LD models.
What's Included
Pair of M1 adjustable monotube loaded front struts.
Installation & Final Checks
Typical install is about 2-3 hours. Perform a complete alignment after setting final ride height. After installation, verify brake-line/ABS-wire clearance, suspension travel and tire-to-body clearance, then retorque suspension hardware after the initial break-in period.
Wheel & tire note: Tire clearance depends on wheel width, offset/backspacing, actual tire dimensions and the vehicle's factory suspension package. Published tire combinations are a guide; aggressive combinations should be test-fit.
Before ordering: Send Serial Killer Customs your year, make, model, drive type, trim, engine and factory suspension options if you are unsure. We would rather verify the application first than send the wrong kit.